I removed the receptacles from the connector on the control harness and clipped them direct to the pins on the board. I heat shrinked every alternate connection to prevent them shorting. For the PSU, I couldn't wait for the correct leads and connectors to come through the post so I hard wired it for a trial. It powered up and runs perfect. The only tweak necessary was to give the brake about a quarter of a turn on the adjuster, this platter is 38mm thick Acrylic and weighs 3.5Kg which is approximately twice that of the stock Technics Platter.
Well that's the drive principle proven, I had better design a deck to put it in.